Overview
The model 5186 is a high input impedance, low-noise, AC-coupled voltage preamplifier which offers a true differential input. It has a frequency response from 0.5 Hz to 1 MHz and three switched gain settings of ×10, ×100 and ×1000. It is a general purpose preamplifier which has the facility to be connected to grounded sources in a manner which breaks ground loops and since it has a true differential input it can be used to measure floating sources, such as the output from an AC bridge, without imposing an asymmetrical load onto the source. It can be powered from its own internally housed (alkaline) batteries, an external low voltage supply (±15 V or ±18 V) or from the model PS0108 remote line power supply (optional extra). This preamplifier can also be powered from most of our range of lock-in amplifiers.
- High input impedance
- True differential input
- Adjustable gain
- 0.5 Hz to 1 MHz frequency response
- Battery or external DC power
- Acoustic research
- Radio astronomy
- AC bridge measurements
- Oscilloscope preamplification
- Hall-effect signal amplification
Specifications
General
AC coupled voltage amplifier with adjustable voltage gain and a maximum frequency response extending from 0.5 Hz to 1 MHz. True differential input and single-ended output via BNC connectors.
Battery powered from internal alkaline batteries or external DC power supplies.
| Inputs | |
| Modes | True differential |
| Coupling | AC |
| Impedance | 100 MΩ // 20 pF |
| Frequency Response | 0.5 Hz to 1 MHz |
| C.M.M.R. x1000 gain |
> 110 dB (100 Hz to 1 kHz), degrading by 6 dB/octave above 1 kHz |
| x10 or x100 gain | >90 dB (100 Hz to 1 kHz), degrading by 6 dB/octave above 1 kHz |
| Max common-mode input voltage, x1000 gain | 5 V pk-pk |
| Max input without damage | ±15 V DC or 10 V rms. AC @ 50 Hz |
| Noise | see Figure1. Typically 4 nV/√Hz @ 1 kHz and x1000 gain; 10 nV/√Hz @ 1 kHz and x10 or x1000 gain |
| Gainx10, x100 or x1000 | switch selectable |
| Gain Accuracy | ±1% |
| Gain Stability | ±150 ppm/ºC |
| Output | |
| Impedance | 450 Ω |
| Max voltage swing | >10 V pk-pk |
| Slow rate | >22 V/µs |
| Polarity | non-inverting |
| Distortion | < 0.01% T.H.D. |
| Power Internal |
Four 9 V alkaline batteries provide approximately 12 hours of use |
| External a) |
±15 V or ±18 V DC @ 27 mA |
| b) | 110 V AC or 240 V AC via optional external model PS0108 power supply |
| Dimensions (excluding connectors) |
8.25" wide x 11" deep x 305" high (210 mm wide x 279 mm deep x 89 mm high) |
| Weight | 5.3 lbs. (2.4) kg) excluding power supply |
… [Trackback]
[…] Find More Info here to that Topic: ino.com.vn/khac-do-luong-kiem-tra/signal-recovery-differential-voltage-preamplifier-model-5186/ […]
… [Trackback]
[…] Info to that Topic: ino.com.vn/khac-do-luong-kiem-tra/signal-recovery-differential-voltage-preamplifier-model-5186/ […]